Display Multicast Routing-Table Static - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Table 6-4 Description on the fields of display multicast routing-table
00001
(172.168.0.2, 227.0.0.1)
Uptime
Upstream interface
List of 2 downstream interfaces

6.1.4 display multicast routing-table static

Syntax
display multicast routing-table static [ config ] [ source-address { mask-length |
mask } ]
View
Any view
Parameters
config: Displays the configuration information of static routes.
source-address: Multicast source address.
mask: Mask of the multicast source address.
mask-length: Mask length of the multicast source address, in the range of 0 to 32.
Description
Use the display multicast routing-table static command to view the information of
multicast static routes.
Examples
# View all the multicast static routes.
<Sysname> display multicast routing-table static
Multicast Routing Table
Routes : 1
Mroute 10.10.0.0/16
Field
Interafce = Vlan-interface1
Matched routing protocol = <none>, Route-policy = <none>
Chapter 6 Multicast Routing and Forwarding
Description
Sequence number of the (S, G) entry
An (S, G) entry of the multicast forwarding table
Length of time for which the (S, G) entry has
been up, in hours:minutes:seconds
Upstream interface the (S, G) entry: multicast
packets should arrive at this interface
Downstream interface list: these interfaces need
to forward multicast packets
RPF Neighbor = 10.10.0.254
6-6
Configuration Commands