Ripng Metricout - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
View
Interface view
Parameters
value: Additional metric for received routes, in the range of 0 to 16.
Description
Use the ripng metricin command to specify an additional metric for received RIPng
routes.
Use the undo ripng metricin command to restore the default.
By default, the additional metric to received routes is 0.
Related commands: ripng metricout.
Examples
# Specify the additional routing metric as 12 for RIPng routes received by
VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ripng metricin 12

2.1.16 ripng metricout

Syntax
ripng metricout value
undo ripng metricout
View
Interface view
Parameters
value: Additional metric to advertised routes, in the range of 1 to 16.
Description
Use the ripng metricout command to configure an additional metric for RIPng routes
advertised by an interface.
Use the undo rip metricout command to restore the default.
The default additional routing metric is 1.
Related commands: ripng metricin.
Chapter 2 IPv6 RIPng Configuration
2-14
Commands