Chapter 1 Acl Configuration Commands; Common Configuration Commands; Display Acl Resource - H3C S7500E Series Command Manual

Command Manual – ACL
H3C S7500E Series Ethernet Switches

Chapter 1 ACL Configuration Commands

1.1 Common Configuration Commands

1.1.1 display acl resource

Syntax
display acl resource [ slot slot-id ]
View
Any view
Parameters
slot-id: Number of the slot.
Description
Use the display acl resource command to display the ACL uses on a switch.
Note that:
Using the command with a specified a slot will display the ACL uses of that slot.
Otherwise, the ACL uses of all slots of the device will be displayed.
If the board specified by the slot number is not in place or not working normally,
this command will display nothing.
Examples
# Display the ACL uses of all slots on the switch.
<Sysname> display acl resource
Interface:
Eth2/0/1 to Eth2/0/24
------------------------------------------------------------------------
Type
------------------------------------------------------------------------
IFP ACL
IFP Meter
IFP Counter 512
Interface:
Eth2/0/25 to Eth2/0/48
------------------------------------------------------------------------
Total Reserved Configured
1024 0
512 0
0
1-1
Chapter 1 ACL Configuration Commands
Remaining
50 974
44 468
0 512