Poe Priority (System View) - H3C S7500E Series Command Manual

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Description
Use the poe priority command to configure a power priority level for a PoE interface.
Use the undo poe priority command to restore the default.
By default, the power priority of a PoE interface is low.
Note that:
When the PoE power is insufficient, power is first supplied to PoE interfaces with a
higher priority level.
If a PoE configuration file is already applied to a PoE interface, you need to
remove the application of the file to the PoE interface before configuring the
interface in PoE-profile view.
If a PoE configuration file is applied to a PoE interface, you need to remove the
application of the file to the PoE interface before configuring the interface in PoE
interface view.
If two PoE interfaces have the same priority level, the PoE interface with a smaller
ID has the higher priority level.
Examples
# Set the power priority of Ethernet 2/0/2 to critical.
<Sysname> system-view
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] poe priority critical
# Set the power priority of Ethernet 2/0/2 to critical through a PoE configuration file.
<Sysname> system-view
[Sysname] poe-profile abc
[Sysname-poe-profile-abc-1] poe priority critical
[Sysname-poe-profile-abc-1] quit
[Sysname] interface Ethernet 2/0/2
[Sysname-Ethernet2/0/2] apply poe-profile name abc

1.1.28 poe priority (system view)

Syntax
poe priority { critical | high | low } [ pse pse-id ]
undo poe priority [ pse pse-id ]
View
System view
Chapter 1 PoE Configuration Commands
1-33