Arp Defense Against Ip Packet Attack Configuration Commands; Arp Resolving-Route Enable - H3C S7500E Series Command Manual

Command Manual – ARP
H3C S7500E Series Ethernet Switches
View
Any view
Parameters
None
Description
Use the display arp source-suppression command to display information about the
current ARP source suppression configuration.
Examples
# Display information about the current ARP source suppression configuration.
<Sysname> display arp source-suppression
ARP source suppression is enabled
Current suppression limit: 100
Current cache length: 16
Table 1-2 Description on fields of display arp source-suppression
ARP source suppression is
enabled
Current suppression limit
Current cache length
1.4 ARP Defense against IP Packet Attack Configuration
Commands

1.4.1 arp resolving-route enable

Syntax
arp resolving-route enable
undo arp resolving-route enable
View
System view
Field
The ARP source suppression function is enabled
Maximum number of packets with the same source
IP address but unresolvable IP addresses that the
device can receive in five seconds
Size of cache used to record source suppression
information
Chapter 1 ARP Configuration Commands
Description
1-10