Reset Acl Ipv6 Counter - H3C S7500E Series Command Manual

Command Manual – ACL
H3C S7500E Series Ethernet Switches
<Sysname> display acl ipv6 2001
Basic IPv6 ACL
ACL's step is 5
rule 0 permit source 1::2/128 (5 times matched)
rule 0 comment This rule is used in eth 2/0/1
Table 1-8 Description on the fields of the display acl ipv6 command
Basic IPv6 ACL 2001
named flow
1 rule
Acl's step is 5
5 times matched
rule 0 comment This rule is
used in eth 2/0/1

1.3.6 reset acl ipv6 counter

Syntax
reset acl ipv6 counter { acl6-number | all | name acl6-name }
View
User view
Parameters
all: All basic and advanced IPv6 ACLs.
acl6-number: IPv6 ACL number, which must be in the following ranges:
2000 to 2999 for basic IPv6 ACLs
3000 to 3999 for advanced IPv6 ACLs
name acl6-name: Specifies the name of the ACL, which is a case insensitive string of 1
to 32 characters. It must start with an English letter and cannot be the English word of
all to avoid confusion.
Description
Use the reset acl ipv6 counter command to clear statistics about a specified or all
IPv6 ACLs that are referenced by upper layer software.
2001, named flow, 1 rule,
Field
The displayed information is about the basic IPv4
ACL 2001.
The name of the ACL is flow.
The ACL contains one rule.
The rules in this ACL are numbered in steps of 5.
Five matches for the rule. Only ACL matches
performed by software are counted.
The field appears as long as one match is found.
The description of ACL rule 5 is "This rule is used in
eth 2/0/1."
Chapter 1 ACL Configuration Commands
Description
1-27