H3C S7500E Series Command Manual page 1359

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
<Sysname> ping ipv6 2001::1
PING 2001::1 : 56
Reply from 2001::1
Reply from 2001::1
Reply from 2001::1
Reply from 2001::1
Reply from 2001::1
--- 2001::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 0/4/20 ms
The "hop limit" field in this prompt information has the same meaning as the "ttl" field in
the prompt information displayed by the IPv4 ping command, indicating the TTL value
in the ICMPv6 echo request.
2.1.3 tracert
Syntax
tracert [ -a source-ip | -f first-ttl | -m max-ttl | -p port | -q packet-number | -w timeout ] *
remote-system
View
Any view
Parameters
-a source-ip: Specifies the source IP address of a tracert packet. It must be a legal IP
address configured on the device.
-f first-ttl: Specifies the first TTL, that is, the allowed number of hops for the first packet,
in the range 1 to 255. It defaults to 1 and must be less than the maximum TTL.
-m max-ttl: Specifies the maximum TTL, that is, the maximum allowed number of hops
for a packet, in the range 1 to 255. It defaults to 30, and must be greater than the first
TTL.
-p port: Specifies the UDP port number of the destination device, in the range 1 to
65535. The default value is 33434. You do not need to modify this parameter.
-q packet-number: Specifies the number of probe packets sent each time, in the range
1 to 65535. The default value is 3.
-w timeout: Specifies the packet timeout time, in the range 1 to 65535, in milliseconds.
The default value is 5000 ms.
data bytes, press CTRL_C to break
bytes=56 Sequence=1 hop limit=64
bytes=56 Sequence=2 hop limit=64
bytes=56 Sequence=3 hop limit=64
bytes=56 Sequence=4 hop limit=64
bytes=56 Sequence=5 hop limit=64
2-4
Chapter 2 System Maintaining and
Debugging Commands
time = 20 ms
time = 0 ms
time = 0 ms
time = 0 ms
time = 0 ms