Primary Accounting - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Note that:
Specifying a source address for the RADIUS packets to be sent to the server can
avoid the situation where the packets sent back by the RADIUS server cannot
reach the device as the result of a physical interface failure. The address of a
loopback interface is recommended.
The nas-ip command in RADIUS scheme view is only for the current RADIUS
scheme, while the radius nas-ip command in system view is for all RADIUS
schemes. However, the nas-ip command in RADIUS scheme view overwrites the
configuration of the radius nas-ip command.
Related commands: radius nas-ip.
Examples
# Set the IP address for the device to use as the source address of the RADIUS
packets to 10.1.1.1.
<Sysname> system-view
[Sysname] radius scheme test1
[Sysname-radius-test1] nas-ip 10.1.1.1

1.2.7 primary accounting

Syntax
primary accounting ip-address [ port-number ]
undo primary accounting
View
RADIUS scheme view
Parameters
ip-address: IP address of the primary accounting server.
port-number: UDP port number of the primary accounting server, which ranges from 1
to 65535.
Description
Use the primary accounting command to configure the IP address and UDP port of
the primary RADIUS accounting server.
Use the undo primary accounting command to restore the defaults.
By default, the default IP address is 0.0.0.0, and the default port number 1813.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the
same. Otherwise, the configuration fails.
Chapter 1 AAA/RADIUS/HWTACACS
1-41
Configuration Commands