H3C S7500E Series Command Manual page 1386

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
View
User view
Parameters
hh:mm: Device reboot wait time, in the format of hh:mm (hours:minutes). The value of
the hh argument ranges of is 0 to 720, and the value of the mm argument ranges from
0 to 59, and the value of the hh:mm argument cannot exceed 720:00.
mm: Device reboot wait time in minutes, in the range of 0 to 43,200.
Description
Use the schedule reboot delay command to enable the scheduled reboot function
and set a reboot wait time.
Use the undo schedule reboot command to disable the scheduled reboot function.
By default, the scheduled reboot function is disabled.
Note that:
The reboot wait time can be in the format of hh:mm (hours:minutes) or mm
(absolute minutes). The absolute minutes cannot exceed 30 x 24 x 60 minutes,
namely, 30 days.
The precision of the device timer is 1 minute. One minute before the reboot time,
the device will prompt "REBOOT IN ONE MINUTE" and will be rebooted in one
minute.
After you execute the above command, the device will prompt you to confirm the
configuration. You must enter <Y> or <y> to make the configuration take effect.
The original configuration will be overwritten at the same time.
If you use the clock command after the schedule reboot delay command to
adjust the system time, the reboot wait time set by the schedule reboot delay
command will become invalid.
If you are performing file operations when the device is to be rebooted, the system
does not execute the command for the sake of security.
Caution:
This command reboots the device after the specified delay time, thus resulting in
service interruption. Please use it with caution.
Examples
# Configure the device to reboot in 88 minutes (supposing the current time is 11:48).
Chapter 3 Device Management Commands
3-23