Chapter 3 Tunneling Configuration Commands; Tunnel Configuration Commands - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches

Chapter 3 Tunneling Configuration Commands

3.1 Tunnel Configuration Commands

3.1.1 aggregation-group
Syntax
aggregation-group aggregation-group-id
undo aggregation-group
View
Tunnel interface view
Parameters
aggregation-group-id: Link aggregation group ID. The value ranges from 1 to 484.
Description
Use the aggregation-group command to reference a link aggregation group.
Use the undo aggregation-group command to remove the link aggregation group
referenced by the tunnel.
By default, a tunnel does not reference any link aggregation group.
Before specifying a link aggregation group for a tunnel in tunnel interface view, you
have configured the manual link aggregation group and set the service type of the link
aggregation group to tunnel in system view.
Make sure the ports in the manual link aggregation group are not up, and STP is
disabled.
One tunnel interface can reference only one link aggregation group.
Related commands: link-aggregation group in Link Aggregation Commands.
Examples
# Create link aggregation group 1, and set the configuration mode to manual and the
service type to tunnel.
<Sysname> system-view
[Sysname] link-aggregation group 1 mode manual
[Sysname] link-aggregation group 1 service-type tunnel
# Add a layer 2 Ethernet interface to link aggregation group 1.
[Sysname] interface ethernet 3/0/1
Chapter 3 Tunneling Configuration Commands
3-1