Dot1X Retry; Dot1X Supp-Proxy-Check - H3C S7500E Series Command Manual

Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches

1.1.11 dot1x retry

Syntax
dot1x retry max-retry-value
undo dot1x retry
View
System view
Parameters
max-retry-value: Maximum number of attempts to send an authentication request to a
supplicant, in the range 1 to 10.
Description
Use the dot1x retry command to set the maximum number of attempts to send an
authentication request to a supplicant.
Use the undo dot1x retry command to restore the default.
By default, the authenticator can send an authentication request to a supplicant for up
to twice.
Note that after sending an authentication request to a supplicant, the authenticator may
retransmit the request if it does not receive any response at an interval specified by the
username request timeout timer or supplicant timeout timer. The number of
retransmission attempts is one less than the value set by this command.
Related commands: display dot1x.
Examples
# Set the maximum number of attempts to send an authentication request to a
supplicant as 9.
<Sysname> system-view
[Sysname] dot1x retry 9

1.1.12 dot1x supp-proxy-check

Syntax
In system view:
dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
undo dot1x supp-proxy-check { logoff | trap } [ interface interface-list ]
In Ethernet interface view:
dot1x supp-proxy-check { logoff | trap }
Chapter 1 802.1x Configuration Commands
1-14