Igmp-Snooping Static-Group - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Parameters
current-interface: Sets the source address of IGMP group-specific queries to the
address of the current VLAN interface. If the current VLAN interface does not have an
IP address, the default IP address 0.0.0.0 will be used as the source IP address of
IGMP group-specific queries.
ip-address: Sets the source address of IGMP group-specific queries to the specified
address.
Description
Use the igmp-snooping special-query source-ip command to configure the source
IP address of IGMP group-specific queries.
Use the undo igmp-snooping special-query source-ip command to restore the
default configuration.
By default, the source IP address of IGMP group-specific queries is 0.0.0.0.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Examples
# Set the IP address of the interface of VLAN 2 to 10.1.1.1, with the subnet mask of
255.255.255.0, and specify this IP address as the source IP address of IGMP
group-specific queries.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] ip address 10.1.1.1 255.255.255.0
[Sysname-Vlan-interface2] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping special-query source-ip current-interface

1.1.24 igmp-snooping static-group

Syntax
igmp-snooping static-group group-address [ source-ip source-address ] vlan
vlan-id
undo igmp-snooping static-group group-address [ source-ip source-address ] vlan
vlan-id
View
Ethernet interface view, port group view
Chapter 1 IGMP Snooping Configuration Commands
1-21