H3C S7500E Series Command Manual page 537

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Peer FE80::20F:E2FF:FE00:220A
Dest 4:3::/64,
via FE80::20F:E2FF:FE00:220A, cost
Table 2-4 Description on the fields of the display ripng route command
Peer
Dest
via
cost
tag
Sec
"A"
"S"
"G"
2.1.7 filter-policy export
Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } export [ protocol
[ process-id ] ]
undo filter-policy export [ protocol [ process-id ] ]
View
RIPng view
Parameters
acl6-number: Specifies the number of an ACL to filter advertised routing information, in
the range of 2000 to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list used to filter
routing information, a string of 1 to 19 characters.
protocol: Filter routes redistributed from a routing protocol, currently including bgp4+,
direct, isisv6, ospfv3, ripng, and static
process-id: Process number of the specified routing protocol, in the range of 1 to 65535.
This argument is specified only when the routing protocol is ripng, ospfv3, or isisv6.
Field
Neighbor connected to the interface
IPv6 destination address
Next hop IPv6 address
Routing metric value
Route tag
Time that a route entry stays in a particular state
The route is in the aging state
The route is in the suppressed state
The route is in the Garbage-collect state
Chapter 2 IPv6 RIPng Configuration
on Vlan-interface100
1, tag 0, A, 34 Sec
Description
2-7
Commands