Display Ipv6 Neighbors - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Hosts use stateless autoconfig for
addresses
# Display the brief IPv6 information of all interfaces for which IPv6 addresses can be
configured.
<Sysname> display ipv6 interface brief
*down: administratively down
(s): spoofing
Interface
Vlan-interface1
Vlan-interface2
Vlan-interface100
Table 1-6 Description on fields of display ipv6 interface brief
Field
*down
(s)
Interface
Physical
Protocol
IPv6 Address

1.1.6 display ipv6 neighbors

Syntax
display ipv6 neighbors { { ipv6-address | all | dynamic | static } [ slot slot-number ] |
interface interface-type interface-number | vlan vlan-id } [ | { begin | exclude | include }
text ]
View
Any view
Field
The interface is down, that is, the interface is closed by using
the shutdown command.
Spoofing attribute of the interface, that is, the link protocol state
of the interface is up, but the link does not exist, or the link is
established on demand, instead of being permanent.
Name of the interface
Physical state of the interface
Link protocol state of the interface
IPv6 address of the interface. Only the first of configured IPv6
addresses is displayed. (If no address is configured for the
interface, "Unassigned" will be displayed.)
1-7
Chapter 1 IPv6 Basics Configuration Commands
Description
Hosts use stateless auto-configuration
mode to acquire IPv6 addresses
Physical Protocol
down down
up up
up down
Description
IPv6 Address
Unassigned
2001::1
Unassigned