H3C S7500E Series Command Manual page 1184

Command Manual – SNMP-RMON
H3C S7500E Series Ethernet Switches
mib-view view-name: Specifies the MIB view name associated with community-name,
where view-name represents the MIB view name, a string of 1 to 32 characters. If no
keyword is specified, the default view is ViewDefault (The view created by the system
after SNMP agent is enabled).
Description
Use the snmp-agent community command to configure a new SNMP community.
Parameters to be configured include access right, community name, ACL, and
accessible MIB views.
Use the undo snmp-agent community command to delete a specified community.
The community name configured with this command is only valid for the SNMP v1 and
v2c agent.
Examples
# Configure a community with the name of comaccess that has read-only access right.
<Sysname> system-view
[Sysname] snmp-agent community read comaccess
# Delete the community comaccess.
<Sysname> system-view
[Sysname] undo snmp-agent community comaccess
1.1.13 snmp-agent group
Syntax
The following syntax applies to SNMPv1 and SNMP v2c:
snmp-agent group { v1 | v2c } group-name [ read-view read-view ] [ write-view
write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group { v1 | v2c } group-name
The following syntax applies to SNMPv3:
snmp-agent group v3 group-name [ authentication | privacy ] [ read-view
read-view ] [ write-view write-view ] [ notify-view notify-view ] [ acl acl-number ]
undo snmp-agent group v3 group-name [ authentication | privacy ]
View
System view
Parameters
v1: SNMPv1.
v2c: SNMPv2c.
Chapter 1 SNMP Configuration Commands
1-13