H3C S7500E Series Command Manual page 717

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Note that:
The tunnel source address is the address of the interface sending packets and is
usually the destination address of the peer tunnel interface.
Two or more tunnel interfaces using the same encapsulation protocol must have
different source addresses and destination addresses.
Related commands: interface tunnel, destination.
Examples
# Set the tunnel source address to VLAN-interface 1 on the interface Tunnel 1/0/3.
<Sysname> system-view
[Sysname] interface tunnel 1/0/3
[Sysname-Tunnel1/0/3] source 192.100.1.1
Or
<Sysname> system-view
[Sysname] interface tunnel 1/0/3
[Sysname-Tunnel1/0/3] source Vlan-interface 1
3.1.8 tunnel-protocol
Syntax
tunnel-protocol { ipv6-ipv4 [ 6to4 | isatap ] | mpls te }
undo tunnel-protocol
View
Tunnel interface view
Parameters
ipv6-ipv4: Sets the tunnel to an IPv6 over IPv4 tunnel.
ipv6-ipv4 6to4: Sets the tunnel to IPv6 over IPv4 6to4 tunnel.
ipv6-ipv4 isatap: Sets the tunnel to an IPv6 over IPv4 ISATAP tunnel.
mpls te :Sets the tunnel to an MPLS TE tunnel. Now S7500E series ethernet switches
do not support MPLS TE tunnel.
Description
Use the tunnel-protocol command to configure the tunnel type.
Use the undo tunnel-protocol to restore the tunnel type to the default.
Note that:
Chapter 3 Tunneling Configuration Commands
3-8