Logfile Save - H3C S7500E Series Command Manual

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
self-defined channel name. For more information, refer to the info-center channel
name command.
Description
Use the info-center trapbuffer command to enable information output to the trap
buffer and set the corresponding parameters.
Use the undo info-center trapbuffer command to disable information output to the
trap buffer.
By default, information output to the trap buffer is enabled with channel 3 (trapbuffer) as
the default channel and a maximum buffer size of 256.
Note that the info-center trapbuffer command takes effect only after the information
center is enabled with the info-center enable command.
Examples
# Enable system to output information to the trap buffer using the default channel, with
a default buffer size of 30.
<Sysname> system-view
[Sysname] info-center trapbuffer size 30

1.1.25 logfile save

Syntax
logfile save
View
Any view
Parameters
None
Description
Use the logfile save command to manually save the log buffer contents into the log file.
By default, the system automatically saves the log file based on a frequency configured
by the info-center logfile frequency command into a directory configured by the
info-center logfile switch-directory command.
Note that all contents in the logfile buffer will be cleared after they are successfully
saved into the log file automatically or manually.
Chapter 1 Information Center Configuration
1-26
Commands