Display Vrrp Statistics - H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches
Delay Time
Auth Type
Track IF
Pri Reduced
Virtual IP
Virtual MAC
Master IP

1.1.2 display vrrp statistics

Syntax
display vrrp statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
Any view
Parameters
interface interface-type interface-number: Displays VRRP statistics of the specified
interface. interface-type interface-number specifies an interface by its type and number.
vrid virtual-router-id: Displays statistics of the specified VRRP group. virtual-router-id
specifies a standby group by its group number, in the range 1 to 255.
Description
Use the display vrrp statistics command to display statistics about VRRP.
If you specify both interface and standby group, only the statistics about the specified
standby group are displayed; if you only specify an interface, the statistics about all the
standby groups on the interface are displayed; if you specify neither, the statistics about
all the standby groups on the device are displayed.
Field
Preemption delay, not displayed when the device works in
non-preemption mode.
Authentication type
The interface to be tracked. It is displayed only after the
execution of the vrrp vrid track command.
The priority value that is reduced when the interface being
tracked is down.
It is displayed only after the execution of the vrrp vrid track
command.
Virtual IP addresses of the standby group
Virtual MAC address corresponding to the virtual IP address
of the standby group. It is displayed only when the switch is
in the state of master.
Primary IP address of the interface to which the switch in the
state of master belongs
Chapter 1 VRRP Configuration Commands
Description
1-3