H3C S7500E Series Command Manual page 1323

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
View
System view
Parameters
None
Description
Use the info-center synchronous command to enable synchronous information
output.
Use the undo info-center synchronous command to disable the synchronous
information output.
By default, the synchronous information output is disabled.
Note:
If system information, such as log information, is output before you input any
information under the current command line prompt, the system will not display the
command line prompt after the system information output.
If system information is output when you are inputting some interactive information
(non Y/N confirmation information), then after the system information output, the
system will not display the command line prompt but your previous input in a new
line.
Examples
# Enable synchronous information output.
<Sysname> system-view
[Sysname] info-center synchronous
% Info-center synchronous output is on
# The user receives log messages when he/she is about to display the configurations
for an Ethernet interface by inputting the display interface ethe command. After the
system has finished its output of log messages, it will display the user's original input,
which is "display interface ethe" in this case.
<Sysname> system-view
[Sysname] display interface ethe
%Aug 14 17:10:33:438 2007 H3C SHELL/4/LOGOUT: VTY logout from 192.168.0.72
[Sysname]display interface ethe
Chapter 1 Information Center Configuration
1-23
Commands