Radius Configuration Commands - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Description
Use the work-directory command to specify the directory accessible to FTP/SFTP
users.
Use the undo work-directory command to restore the default.
By default, FTP/SFTP users can access the root directory of the device.
Note that:
The specified directory accessible to users must exist.
If you use a file system command to delete the specified directory, FTP/SFTP
users will no longer access the directory.
If the specified directory carries with information about the slot where the
secondary
primary-to-secondary switching. It is not recommended to carry with slot
information when you specify a work directory.
Examples
# Specify the directory accessible to FTP/SFTP users.
<Sysname> system-view
[Sysname] local-user user1
[Sysname-luser-user1] work-directory flash:

1.2 RADIUS Configuration Commands

1.2.1 data-flow-format
Syntax
data-flow-format { data { byte | giga-byte | kilo-byte | mega-byte } | packet
{ giga-packet | kilo-packet | mega-packet | one-packet } }*
undo data-flow-format { data | packet }
View
RADIUS scheme view
Parameters
data: Specifies the unit for data flows, which can be byte, kilobyte, megabyte, or
gigabyte.
packet: Specifies the unit for data packets, which can be one-packet, kilo-packet,
mega-packet, or giga-packet.
board is inserted,
1-32
Chapter 1 AAA/RADIUS/HWTACACS
FTP/SFTP users cannot
Configuration Commands
log in after