Pim Require-Genid - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Description
Use the pim holdtime join-prune command to configure the join/prune timeout time
on the interface.
Use the undo pim holdtime join-prune command to restore the system default.
By default, the join/prune timeout time is 210 seconds.
Related commands: holdtime assert, pim holdtime assert, holdtime join-prune.
Examples
# Set the join/prune timeout time to 280 seconds on VLAN-interface 100.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim holdtime join-prune 280

4.1.43 pim require-genid

Syntax
pim require-genid
undo pim require-genid
View
Interface view
Parameters
None
Description
Use the pim require-genid command enable rejection of hello messages without
Generation_ID.
Use the undo pim require-genid command to restore the default configuration.
By default, hello messages without Generation_ID are accepted.
Examples
# Enable VLAN-interface 100 to reject hello messages without Generation_ID.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] pim require-genid
Chapter 4 PIM Configuration Commands
4-40