H3C S7500E Series Command Manual page 901

Command Manual – 802.1x - MAC Authentication
H3C S7500E Series Ethernet Switches
Authenticate state
AuthIndex
3.1.2 mac-authentication
Syntax
mac-authentication [ interface interface-list ]
undo mac-authentication [ interface interface-list ]
View
System view, Ethernet interface view
Parameters
interface interface-list: Specifies an Ethernet port list, in the format of { interface-type
interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
indicates that you can specify up to 10 port ranges. A port range defined without the to
interface-type interface-number portion comprises only one port.
Description
Use the mac-authentication command to enable MAC authentication globally or for
one or more ports.
Use the undo mac-authentication command to disable MAC authentication globally
or for one or more ports.
By default, MAC authentication is neither enabled globally nor enabled on any port.
Note that:
In system view, if you provide the interface-list argument, the command enables
MAC authentication for the specified ports; otherwise, the command enables MAC
authentication globally. In Ethernet interface view, the command enables MAC
authentication for the port without requiring the interface-list argument.
You can configure MAC authentication parameters globally or for specified ports
either before or after enabling MAC authentication. If no MAC authentication
Field
3-3
Chapter 3 MAC Authentication Configuration
Description
User status. Possible values are:
CONNECTING: The user is logging
in.
SUCCESS: The user has passed the
authentication.
FAILURE: The
authentication.
LOGOFF: The user has logged off.
Authenticator Index
Commands
user failed the