Display Vrrp Ipv6 Statistics - H3C S7500E Series Command Manual

Command Manual – HA
H3C S7500E Series Ethernet Switches

1.2.2 display vrrp ipv6 statistics

Syntax
display vrrp ipv6 statistics [ interface interface-type interface-number [ vrid
virtual-router-id ] ]
View
Any view
Parameters
interface interface-type interface-number: Displays VRRP statistics information of the
specified interface. interface-type interface-number specifies an interface by its type
and number.
vrid virtual-router-id: Displays statistics information of the specified VRRP group.
virtual-router-id specifies a standby group by its group number, in the range 1 to 255.
Description
Use the display vrrp ipv6 statistics command to display statistics about VRRP for
IPv6.
If you specify both interface and standby group, only the statistics about the specified
standby group are displayed; if you only specify an interface, the statistics about all the
standby groups on the interface are displayed; if you specify neither, the statistics about
all the standby groups on the device are displayed.
Examples
# Display the statistics about all standby groups for IPv6.
<Sysname> display vrrp ipv6 statistics
Interface
VRID
CheckSum Errors
Invalid Type Pkts Rcvd : 0
Hop Limit Errors
Invalid Auth Type
Packet Length Errors
Become Master
Advertise Rcvd
Advertise Sent
Interface
VRID
CheckSum Errors
Chapter 1 VRRP Configuration Commands
: Vlan-interface100
: 80
: 0 Version Errors
Advertisement Interval Errors
: 0 Auth Failures
: 0 Auth Type Mismatch
: 0 Address List Errors
: 1 Priority Zero Pkts Rcvd
: 0 Priority Zero Pkts Sent
: 20
: Vlan-interface200
: 10
: 0 Version Errors
1-16
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0