H3C S7500E Series Command Manual page 964

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
secondary server remains the same. If the secondary server fails, the device
restores the status of the primary server to active immediately.
If the primary server has resumed, the device turns to use the primary server and
stops communicating with the secondary server. After accounting starts, the
communication between the client and the secondary server remains
unchanged.
If both the primary server and the secondary server are in the state of active or
blocked, the device sends the packets only to the primary server.
If one server is in the active state while the other is blocked, the switchover will
not take place even if the active server is not reachable.
Related
authentication, primary accounting, secondary accounting.
Examples
# Set the status of the secondary server in RADIUS scheme radius1 to active.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] state secondary authentication active
1.2.23 stop-accounting-buffer enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
View
RADIUS scheme view
Parameters
None
Description
Use the stop-accounting-buffer enable command to enable the device to buffer
stop-accounting requests getting no responses.
Use the undo stop-accounting-buffer enable command to disable the device from
buffering stop-accounting requests getting no responses.
By default, the device is enabled to buffer stop-accounting requests getting no
responses.
Since stop-accounting requests affect the charge to users, a NAS must make its best
effort to send every stop-accounting request to the RADIUS accounting servers. For
each stop-accounting request getting no response in the specified period of time, the
commands: radius
Chapter 1 AAA/RADIUS/HWTACACS
scheme, primary
1-55
Configuration Commands
authentication, secondary