Vrrp Vrid Priority - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – HA

H3C S7500E Series Ethernet Switches

# Enable preemption on the router in VRRP standby group 1, and set the preemption

delay to five seconds.

<Sysname> system-view

[Sysname] interface vlan-interface 2

[Sysname-Vlan-interface2] vrrp vrid 1 preempt-mode timer delay 5

1.1.9 vrrp vrid priority

vrrp vrid virtual-router-id priority priority-value

undo vrrp vrid virtual-router-id priority

Interface view

virtual-router-id: VRRP standby group number, in the range 1 to 255.

priority-value: Priority value of the router in the specified standby group, in the range 1

to 254, with a higher number indicating a higher priority.

Use the vrrp vrid priority command to configure the priority of the switch in the

specified standby group.

Use the undo vrrp vrid priority command to restore the default.

By default, the priority of a switch in a standby group is 100.

Before executing the command, create a standby group on an interface and

configure the virtual IP address of the standby group.

In VRRP, the role that a switch plays in a standby group depends on its priority. A

higher priority means that the switch is more likely to become the master. Note that

priority 0 is reserved for special use and 255 for the IP address owner.

If the switch is the IP address owner, its priority is always 255. Therefore, it will be

the master so long as it is functioning normally.

# Set the priority of standby group 1 on interface VLAN-interface 2 to 150.

<Sysname> system-view

[Sysname] interface vlan-interface 2

[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.1.1.1

[Sysname-Vlan-interface2] vrrp vrid 1 priority 150

Chapter 1 VRRP Configuration Commands

Table of Contents