H3C S7500E Series Command Manual page 1136

Command Manual – QoS
H3C S7500E Series Ethernet Switches
Parameters
vlan-id-value: VLAN ID to be set for packets, in the range of 1 to 4094.
Description
Use the remark service-vlan-id command to configure the action of setting the service
provider network VLAN ID for a traffic behavior.
Use the undo remark service-vlan-id command to remove the action of setting the
service provider network VLAN ID.
Note that:
When the action of setting the service provider network VLAN ID is applied in the
inbound direction, any other action except the traffic filtering action or the action of
setting 802.1p precedence cannot be configured in the same traffic behavior.
Otherwise, the corresponding QoS policy cannot be applied successfully.
The action of setting the service provider network VLAN ID cannot he applied to a
VLAN or applied globally.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the action of setting the service provider network VLAN ID to 2 for a traffic
behavior.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] remark service-vlan-id 2
2.2.14 traffic behavior
Syntax
traffic behavior behavior-name
undo traffic behavior behavior-name
View
System view
Parameters
behavior-name: Name of the traffic behavior to be created.
Description
Use the traffic behavior command to create a traffic behavior. This command also
leads you to traffic behavior view.
Use the undo traffic classifier command to remove a traffic behavior.
Chapter 2 QoS Policy Configuration Commands
2-17