Display Rrpp Statistics - H3C S7500E Series Command Manual

Command Manual – RRPP
H3C S7500E Series Ethernet Switches
Table 1-1 Description on the fields of the display rrpp brief command
Flags for Node Mode
RRPP Protocol Status
Number of RRPP Domains
Domain ID
Control VLAN
Hello Timer
Fail Timer
Ring ID
Ring Level
Node Mode
Primary/Common Port
Secondary/Edge Port
Enable Status

1.1.3 display rrpp statistics

Syntax
display rrpp statistics domain domain-id [ ring ring-id ]
View
Any view
Parameters
domain-id: RRPP domain ID, in the range 1 to 8.
Field
RRPP node mode: M represents master node, T
represents transit node, E represents edge node
and A represents assistant edge node
RRPP protocol status: Enable (globally
enabled)/Disable (globally disabled)
Number of RRPP domains configured
RRPP domain ID
Control VLANs of an RRPP domain: Major and
Sub
Hello Timer value configured in seconds
Fail Timer value configured in seconds
RRPP ring ID
RRPP ring level, with 0 representing primary ring
and 1 representing subring
Node mode
Primary port when the node mode is master node
or transit node; common port when the node mode
is edge node or assistant edge node; "-" appears
when the port is not configured on the ring or the
board to which the port belongs does not start.
Secondary port when the node mode is master
node or transit node; edge port when the node
mode is edge node or assistant edge node;
"-" appears when the port is not configured on the
ring or the board to which the port belongs does
not start.
RRPP ring status: Yes indicates enabled and No
indicates disabled.
1-3
Chapter 1 RRPP Configuration Commands
Description