Poe-Power Input-Threshold - H3C S7500E Series Command Manual

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Parameters
utilization-threshold-value: Power alarm threshold in percentage, in the range 1 to 99.
pse pse-id: Specifies a PSE ID.
Description
Use the poe utilization-threshold command to configure a power alarm threshold for
the PSE.
Use the undo poe utilization-threshold command to restore the default power alarm
threshold of the PSE.
By default, the power alarm threshold for the PSE is 80%.
The system sends a Trap message when the percentage of power utilization exceeds
the alarm threshold. If the percentage of the power utilization always keeps above the
alarm threshold, the system does not send any Trap message. Instead, when the
percentage of the power utilization drops below the alarm threshold, the system sends
a Trap message again.
Examples
# Set the power alarm threshold of PSE 7 to 90%.
<Sysname> system-view
[Sysname] poe utilization-threshold 90 pse 7

1.1.32 poe-power input-threshold

Syntax
poe-power input-threshold { lower | upper } value
undo poe-power input-threshold { lower | upper }
View
System view
Parameters
lower value: Specifies an under-voltage threshold in volts, in the range 90 to 264, with
the default value being 90.
upper value: Specifies an over-voltage threshold in volts, in the range 90 to 264, with
the default value being 264.
Description
Use the poe-power input-threshold command to configure an AC input
under-voltage/over-voltage threshold.
Use the undo poe-power input-threshold command to restore the default.
Chapter 1 PoE Configuration Commands
1-36