H3C S7500E Series Command Manual page 1321

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
channel-number: Specifies a channel number, in the range 0 to 9.
channel-name: Specifies a channel name, which could be a default name or a
self-defined name. The user needs to specify a channel name first before using it as a
self-defined channel name. For more information, refer to the info-center channel
name command.
Description
Use the info-center source command to specify the output rules of the system
information.
Use the undo info-center source command to remove the specified output rules.
By default, the output rules for the system information are listed in
This command can be used to configure the filter and redirection rules of
log/trap/debugging information.
For example, the user can set to output log information with severity higher than
warnings to the log host, and information with severity higher than informational to the
log buffer. The user can also set to output trap information of the IP module to a
specified output destination.
Note that:
If you do not use the module-name argument to set output rules for a module, the
module uses the default output rules or the output rules set by the default keyword;
otherwise the module uses the output rules separately set for it.
When you use the module-name argument to separately set the output rules for a
module, the default output rules for the module are as follows: Log and trap
information is enabled, with severity being informational; debugging information is
disabled, with severity being debugging.
After you separately set the output rules for a module, you must use the
module-name argument to modify or remove the rules. The new configuration by
using the default keyword is invalid on the module.
Table 1-10 Default output rules for different output destinations
Output
destinati
on
Console
LOG
Module
s
Enable
allowed
d/disab
led
default
(all Enable
modules d
)
1-21
Chapter 1 Information Center Configuration
TRAP
Enable
Severit
d/disab
y
led
warning Enable debug
s d ging
Commands
Table 1-10.
DEBUG
Enable
Severi Severit
d/disab
ty
led
Enable debugg
d ing
y