Display Igmp Interface - H3C S7500E Series Command Manual

Command Manual – Multicast
H3C S7500E Series Ethernet Switches
Table 3-2 Description on the fields of the display igmp group port-info command
Total1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port,
S-Static port, A-Aggregation
port, C-Copy port
Subvlan flags: R-Real VLAN,
C-Copy VLAN
Router port(s)
IP group address
MAC group address
Attribute
Host port(s)

3.1.3 display igmp interface

Syntax
display igmp interface [ interface-type interface-number ] [ verbose ]
View
Any view
Parameters
interface-type interface-number: Specifies an interface to display the IGMP information
about. If no interface is specified, this command will display the related information of all
IGMP-enabled interfaces.
verbose: Displays the detailed IGMP configuration and running information.
Description
Use the display igmp interface command to view IGMP configuration and running
information of the specified interface or all IGMP-enabled interfaces.
Host port(s):total 1 port.
Eth1/0/1
Field
Chapter 3 IGMP Configuration Commands
Description
Total number of IP multicast groups
Total number of IP multicast sources
Total number of MAC multicast groups
Port flags: D for dynamic port, S for static port, A for
aggregation port, C for port copied from a (*, G)
entry to an (S, G) entry
Sub-VLAN flags: R for real egress sub-VLAN
under the current entry, C for sub-VLAN copied
from a (*, G) entry to an (S, G) entry
Number of router ports
Address of IP multicast group
Address of MAC multicast group
Attribute of IP multicast group
Number of host member ports
3-4