Refresh Bgp Ipv - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
5.1.59 reflector cluster-id
Syntax
reflector cluster-id cluster-id
undo reflector cluster-id
View
IPv6 address family view
Parameters
cluster-id: Specifies the cluster ID of the route reflector, an integer from 1 to
4294967295 (the system translates it into an IPv4 address) or an IPv4 address.
Description
Use the reflector cluster-id command to configure the cluster ID of the route reflector.
Use the undo reflector cluster-id command to remove the configured cluster ID.
By default, a route reflector uses its router ID as the cluster ID.
Usually, there is only one route reflector in a cluster, so the router ID of the route
reflector identifies the cluster. If multiple route reflectors are configured to improve the
stability of the network, you should use this command to configure the identical cluster
ID for all the reflectors to avoid routing loops.
Related commands: reflect between-clients, peer reflect-client.
Examples
# Set 50 as the cluster ID for the route reflector, which is one of multiple route reflectors
in the cluster.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6] reflector cluster-id 50

5.1.60 refresh bgp ipv6

Syntax
refresh bgp ipv6 { ipv6-address | all | external | group ipv6-group-name | internal }
{ export | import }
View
User view
Chapter 5 IPv6 BGP Configuration Commands
5-50