Mtu (Tunnel Interface View) - H3C S7500E Series Command Manual

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches

3.1.6 mtu (tunnel interface view)

Syntax
mtu mtu-size
undo mtu
View
Tunnel interface view
Parameters
mtu-size: Tunnel interface MTU in bytes, in the range of 100 to 64,000.
Description
Use the mtu command to configure the tunnel interface MTU.
Use the undo mtu command to restore the default tunnel interface MTU.
Examples
# Set the tunnel interface MTU to 10,000 bytes.
<Sysname> system-view
[Sysname] interface tunnel 1/0/3
[Sysname-Tunnel1/0/3] mtu 10000
3.1.7 source
Syntax
source { ip-address | interface-type interface-number }
undo source
View
Tunnel interface view
Parameters
ip-address: Tunnel source IPv4 address.
interface-type interface-number: Specifies an interface. The interface types include
Vlan-interface, tunnel, and so on.
Description
Use the source command to specify the source address for the tunnel interface.
Use the undo source command to remove the configured tunnel source address.
By default, no tunnel source address is configured.
Chapter 3 Tunneling Configuration Commands
3-7