Info-Center Loghost Source; Info-Center Monitor Channel - H3C S7500E Series Command Manual

Command Manual – Information Center
H3C S7500E Series Ethernet Switches
Examples
# Set to output log information to a Unix station with the IP address being 1.1.1.1/16.
<Sysname> system-view
[Sysname] info-center loghost 1.1.1.1

1.1.17 info-center loghost source

Syntax
info-center loghost source interface-type interface-number
undo info-center loghost source
View
System view
Parameters
interface-type interface-number: Specifies a source interface by its type and number.
Description
Use the info-center loghost source command to configure the source interface to
output log information to the log host.
Use the undo info-center loghost source command to remove the source interface
to output log information to the log host.
By default, no source interface is configured to output log information to the log host,
and the system selects an interface as the source interface.
Note that the info-center loghost source command takes effect only after the
information center is enabled with the info-center enable command.
Examples
# Configure the interface VLAN-interface 1 as the source interface to output log
information to the log host.
<Sysname> system-view
[Sysname] info-center loghost source Vlan-interface 1

1.1.18 info-center monitor channel

Syntax
info-center monitor channel { channel-number | channel-name }
undo info-center monitor channel
Chapter 1 Information Center Configuration
1-18
Commands