H3C S7500E Series Command Manual page 551

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
undo default cost
View
OSPFv3 view
Parameters
value: Specifies a default cost for redistributed routes, in the range of 1 to 16777214.
Description
Use the default cost command to configure a default cost for redistributed routes.
Use the undo default cost command to restore the default.
By default, the default cost is 1.
You need to configure the default cost value for redistributed routes to advertise them
throughout the whole AS.
If multiple OSPFv3 processes are available, use of this command takes effect for the
current process only.
Examples
# Specify the default cost for redistributed routes as 10.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] default cost 10
3.1.4 default-cost
Syntax
default-cost value
undo default-cost
View
OSPFv3 area view
Parameters
value: Specifies a cost for the default route advertised to the stub area, in the range of 0
to 65535. The default is 1.
Description
Use the default-cost command to specify the cost of the default route to be advertised
to the stub area.
Use the undo-default-cost command to restore the default value.
Chapter 3 IPv6 OSPFv3 Configuration Commands
3-3