H3C S7500E Series Command Manual page 627

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
View
BGP view
Parameters
None
Description
Use the ipv6-family command to enter IPv6 address family view.
Use the undo ipv6-family command to remove all configurations from the view.
IPv4 BGP unicast view is the default.
Examples
# Enter IPv6 address family view.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv6-family
[Sysname-bgp-af-ipv6]
5.1.30 network
Syntax
network ipv6-address prefix-length [ short-cut | route-policy route-policy-name ]
undo network ipv6-address prefix-length [ short-cut ]
View
IPv6 address family view
Parameters
ipv6-address: IPv6 address.
prefix-length: Prefix length of the address, in the range 0 to 128.
short-cut: If the keyword is specified for an EBGP route, the route will use the local
routing management value rather than that of EBGP routes, so the preference of the
route is reduced.
route-policy-name: Name of a routing policy, a string of 1 to 19 characters.
Description
Use the network command to advertise a network to the IPv6 BGP routing table.
Use the undo network command to remove an entry from the IPv6 BGP routing table.
By default, no route is advertised.
Chapter 5 IPv6 BGP Configuration Commands
5-27