H3C S7500E Series Command Manual page 1417

Command Manual – HA
H3C S7500E Series Ethernet Switches
Parameters
virtual-router-id: VRRP standby group number, in the range 1 to 255.
virtual-address: Virtual IPv6 address.
link-local: Indicates that the virtual IPv6 address of the standby group is a link local
address.
Description
Use the vrrp ipv6 vrid virtual-ip link-local command to create a standby group and
assign the first virtual IPv6 address to the specified standby group. The first virtual IPv6
address assigned to a standby group must be a link local address and only one such
address is allowed in a standby group.
Use the vrrp ipv6 vrid virtual-ip command to add a virtual IPv6 address to a standby
group.
Use the undo vrrp ipv6 vrid command to remove a standby group.
Use the undo vrrp ipv6 vrid virtual-router-id virtual-ip virtual-address [ link-local ]
command to remove a virtual IPv6 address from a standby group.
After you remove all virtual IPv6 addresses, the standby group is automatically
removed. Note that the first address assigned to the group must be removed the last.
By default, no standby group is created.
Examples
# Create standby group 1, and configure its virtual IPv6 address as fe80::10.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10
# Configure the virtual IPv6 address of standby group 1 as 1::10.
[Sysname-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip 1::10
Chapter 1 VRRP Configuration Commands
1-25