Display Ospfv3 Peer - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – IPv6 Routing

H3C S7500E Series Ethernet Switches

Use the display ospfv3 next-hop command to display OSPFv3 next hop information.

If no process is specified, next hop information of all OSPFv3 processes is displayed.

# Display OSPFv3 next hop information.

<Sysname> display ospfv3 next-hop

Table 3-6 Description on the fields of the display ospfv3 next-hop command

3.1.10 display ospfv3 peer

display ospfv3 [ process-id ] [ area area-id ] peer [ [ interface-type interface-number ]

[ verbose ] | peer-router-id ]

process-id: Specifies the ID of an OSPFv3 process, ranging from 1 to 65535.

area: Specifies to display neighbor information of the specified area.

area-id: The ID of an area, a decimal integer that is translated into IPv4 address format

by the system (in the range of 0 to 4294967295) or an IPv4 address.

interface-type interface-number: interface type and number.

verbose: Display detailed neighbor information.

peer-router-id: Router-ID of the specified neighbor.

OSPFv3 Router with ID (2.2.2.2) (Process 1)

FE80::20F:E2FF:FE00:1

Chapter 3 IPv6 OSPFv3 Configuration Commands

Neighboring router ID

Next-hop address

Outbound interface

Reference count

Table of Contents