H3C S7500E Series Command Manual page 981

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
Examples
# Configure the secondary accounting server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary accouting 10.163.155.12 49
1.3.15 secondary authentication
Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the secondary authentication command to specify the secondary HWTACACS
authentication server.
Use the undo secondary authentication command to remove the configuration.
Note that:
The IP addresses of the primary and secondary authentication servers cannot be
the same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an authentication server only when no active TCP connection for
sending authentication packets is using it.
Related commands: display hwtacacs.
Examples
# Configure the secondary authentication server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authentication 10.163.155.13 49
Chapter 1 AAA/RADIUS/HWTACACS
1-72
Configuration Commands