H3C S7500E Series Command Manual page 1349

Command Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
CTRL_U: Assigns the hot key <Ctrl+U> to a command.
command: The command line associated with the hot key.
Description
Use the hotkey command to assign a hot key to a command line.
Use the undo hotkey command to restore the default.
By default, the system specifies corresponding commands for <Ctrl+G>, <Ctrl+L> and
<Ctrl+O>, while the others are null.
<Ctrl+G> corresponds to display current-configuration
<Ctrl+L> corresponds to display ip routing-table
<Ctrl+O> corresponds to undo debugging all
You can customize this scheme as needed however.
Examples
# Assign the hot key <Ctrl+T> to the display tcp status command.
<Sysname> system-view
[Sysname] hotkey ctrl_t display tcp status
# Display the configuration of hotkeys.
[Sysname] display hotkey
----------------- HOTKEY -----------------
Hotkeys Command
CTRL_G
CTRL_L
CTRL_O
CTRL_T
Hotkeys Command
CTRL_U
Hotkeys Function
CTRL_A
CTRL_B
CTRL_C
CTRL_D
CTRL_E
CTRL_F
CTRL_H
=Defined hotkeys=
display current-configuration
display ip routing-table
undo debug all
display tcp status
=Undefined hotkeys=
NULL
=System hotkeys=
Move the cursor to the beginning of the current line.
Move the cursor one character left.
Stop current command function.
Erase current character.
Move the cursor to the end of the current line.
Move the cursor one character right.
Erase the character left of the cursor.
Chapter 1 Basic Configuration Commands
1-17