H3C S7500E Series Command Manual page 533

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Description
Use the display ripng command to display the running status and configuration
information of a RIPng process. If process-id is not specified, information of all RIPng
processes will be displayed.
Examples
# Display the running status and configuration information of all configured RIPng
processes.
<Sysname> display ripng
RIPng process : 1
Preference : 100
Checkzero : Enabled
Default Cost : 0
Maximum number of balanced paths : 3
Update time
Suppress time
Number of periodic updates sent : 0
Number of trigger updates sent : 0
Table 2-1 Description on the fields of the display ripng command
RIPng Process
Preference
Checkzero
Default Cost
Maximum number of balanced
paths
Update time
Timeout time
Suppress time
Garbage-Collect time
Number of periodic updates sent
Number of trigger updates sent
: 30 sec(s)
: 120 sec(s)
Field
2-3
Chapter 2 IPv6 RIPng Configuration
Timeout time
Garbage-Collect time :
Description
RIPng process ID
RIPng route priority
Whether zero field check for RIPng packet
headers is enabled
Default metric of redistributed routes
Maximum number of load balanced routes
RIPng updating interval, in seconds
RIPng timeout interval, in seconds
RIPng suppress interval, in seconds
RIPng garbage collection interval, in seconds
Number of periodic updates sent
Number of triggered updates sent
Commands
: 180 sec(s)
240 sec(s)