H3C S7500E Series Command Manual page 1130

Command Manual – QoS
H3C S7500E Series Ethernet Switches
2.2.6 redirect
Syntax
redirect { cpu | interface interface-type interface-number | link-aggregation group
agg-id | next-hop { ipv4-add [ ipv4-add ] | ipv6-add [ interface-type interface-number ]
[ ipv6-add [ interface-type interface-number ] ] } }
undo redirect
View
Traffic behavior view
Parameters
cpu: Redirects traffic to the CPU.
interface interface-type interface-number: Redirects traffic to an interface identified by
its type and number.
link-aggregation group agg-id: Redirects traffic to a manual aggregation group. The
agg-id argument is an aggregation group ID. Note that the specified aggregation group
must be an existing manual aggregation group.
next-hop: Specifies the next hop to redirect the traffic to.
ipv4-add: IPv4 address of the next hop.
ipv6-add: IPv6 address of the next hop. The interface-type interface-number argument
is a VLAN interface number. If the IPv6 address is a link-local address, you must
specify a VLAN interface for the IPv6 address of the next hop; if the IPv6 address is not
a link-local address, you need not specify a VLAN interface for the IPv6 address of the
next hop.
Description
Use the redirect command to configure traffic redirecting action for a traffic behavior.
Use the undo redirect command to remove the traffic redirecting action.
Related commands: qos policy, traffic behavior, classifier behavior.
Examples
# Configure the redirecting action to redirect traffic to Ethernet2/0/1 port.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] redirect interface Ethernet 2/0/1
Chapter 2 QoS Policy Configuration Commands
2-11