Display Time-Range - H3C S7500E Series Command Manual

Command Manual – ACL
H3C S7500E Series Ethernet Switches
Table 1-1 Description on the fields of the display acl resource command
Field
Interface
Type
Total
Reserved
Configured
Remaining

1.1.2 display time-range

Syntax
display time-range { time-name | all }
View
Any view
Parameters
time-name: Time range name comprising 1 to 32 characters. It is case insensitive and
must start with an English letter. To avoid confusion, this name cannot be all.
all: All existing time ranges.
Description
Use the display time-range command to display the configuration and state of a
specified or all time ranges.
A time range is active if the system time falls into its range, and if otherwise, inactive.
Examples
# Display the configuration and state of time range trname.
<Sysname> display time-range trname
Current time is 22:20:18 1/5/2006 Thursday
Interface indicated by its type and number
Resource type:
ACL indicates ACL rule resources,
Meter indicates traffic policing resources,
Counter indicates traffic statistics resources,
IFP indicates the count of resources in the inbound direction,
EFP indicates the count of resources in the outbound direction
VFP indicates the count of resources that are before Layer 2
forwarding and applied in QinQ.
Total number of ACLs supported
Number of reserved ACLs
Number of configured ACLs
Number of remaining ACLs
1-3
Chapter 1 ACL Configuration Commands
Description