H3C S7500E Series Command Manual page 961

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches
View
RADIUS scheme view
Parameters
ip-address: IP address of the secondary authentication/authorization server, in dotted
decimal notation. The default is 0.0.0.0.
port-number: UDP port number of the secondary authentication/authorization server,
which ranges from 1 to 65535 and defaults to 1812.
Description
Use the secondary authentication command to configure the IP address and UDP
port of the secondary RADIUS authentication/authorization server.
Use the undo secondary authentication command to restore the defaults.
Note that:
The IP addresses of the primary and secondary authentication/authorization
servers cannot be the same. Otherwise, the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS server
must be consistent.
Related commands: key, radius scheme, state.
Examples
# Set the IP address of the secondary authentication/authorization server for RADIUS
scheme radius1 to 10.110.1.2 and the UDP port of the server to 1812.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary authentication 10.110.1.2 1812
1.2.20 security-policy-server
Syntax
security-policy-server ip-address
undo security-policy-server { ip-address | all }
View
RADIUS scheme view
Parameters
ip-address: IP address of a security policy server.
all: All IP addresses
Chapter 1 AAA/RADIUS/HWTACACS
1-52
Configuration Commands