Tftp Client Source - H3C S7500E Series Command Manual

Command Manual – File System Management
H3C S7500E Series Ethernet Switches
File will be transferred in binary mode
Sending file to remote tftp server. Please wait... \
TFTP:
File uploaded successfully.

3.1.4 tftp client source

Syntax
tftp client source { interface interface-type interface-number | ip source-ip-address }
undo tftp client source
View
System view
Parameters
interface interface-type interface-number: Specifies the source interface by its type
and number. The primary IP address configured on the source interface is the source IP
address of the packets sent by FTP. If no primary IP address is configured on the
source interface, the transmission fails.
ip source-ip-address: The source IP address of the TFTP connection. It must be an IP
address that has been configured on the device.
Description
Use the tftp client source command to configure the source address of the TFTP
packets from the TFTP client.
Use the undo telnet client source command to restore the default.
By default, a device uses the IP address of the interface determined by the routing
protocol as the source IP address to communicate with a TFTP server.
Note that:
The source address includes the source interface and the source IP, if you use the
tftp client source command to specify the source interface and the source IP, the
newly specified source IP overwrites the original one and vice versa.
If the source address is specified with the tftp client source command and then
with the tftp command, use the latter one.
The source address specified with the tftp client source command is valid for all
tftp connections and the source address specified with the tftp command is valid
for the current tftp command.
Related commands: display tftp client configuration.
Examples
# Specify the source IP address of the TFTP client to 2.2.2.2.
2143 bytes sent in 0 second(s).
3-4
Chapter 3 TFTP Configuration Commands