Ssh Client Ipv6 Source - H3C S7500E Series Command Manual

Command Manual – SSH
H3C S7500E Series Ethernet Switches
Description
Use the ssh client first-time enable command to enable the first authentication
function.
Use the undo ssh client first-time command to disable the function.
By default, the function is enabled.
When an SSH client tries to access a server whose public host key it does not know for
the first time, the first authentication function enables it to access the server and obtain
and save the public host key of the server. When the client accesses the server later, it
can use the locally saved public host key of the server to authenticate the server.
With the first authentication function disabled, an SSH client cannot access any server
whose public host key it does not know. In this case, you must configure the public host
key of the server to be accessed and specify the public key name on the client at first.
Examples
# Enable the first authentication function.
<Sysname> system-view
[Sysname] ssh client first-time enable

1.1.24 ssh client ipv6 source

Syntax
ssh client
interface-number }
undo ssh client ipv6 source
View
System view
Parameters
ipv6 ipv6-address: Specifies a source IPv6 address.
interface interface-type interface-number: Specifies a source interface by its type and
number.
Description
Use the ssh client ipv6 source command to specify the source IPv6 address or
source interface for the SSH client.
Use the undo ssh client ipv6 source command to remove the configuration.
By default, the client uses the source address specified by the route of the device to
access the SSH server.
ipv6 source { ipv6
1-20
Chapter 1 SSH Configuration Commands
ipv6-address | interface interface-type