H3C S7500E Series Command Manual page 1468

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Port Operating Status
Port IEEE class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak Power
Port Max Power
Port Current
Port Voltage
Port PD Description
Field
Operating state of a PoE interface:
off: PoE is disabled.
on: Power is supplied for a PoE interface normally.
power lack: The guaranteed remaining power of the
PSE is not high enough to supply power for a critical
PoE interface.
power-deny: The PSE refuses to supply power. The
power required by the powered device (PD) is higher
than the configured power.
power-itself: The external equipment is supplying
power for itself.
power-limit: The PSE is supplying a limited power. The
power required by the PD is higher than the configured
power and the PSE still supplies the configured power.
PD power class: 0, 1, 2, 3, 4
Power detection state of a PoE interface:
disabled: The PoE function is disabled.
searching: The PoE interface is searching for the
PD.
delivering-power: The PoE interface is supplying
power for the PD.
fault: There is a fault defined in 802.3af.
test: The PoE interface is under test.
other-fault: There is a fault other than defined in
802.3af.
pd-disconnect: The PD is disconnected.
Port detection status varies with devices.
Power mode of a PoE interface:
signal: Power is supplied over signal cables.
spare: Power is supplied over spare cables.
Current power of a PoE interface, including PD
consumption power and transmission loss
The transmission loss usually does not exceed one
watt.
Average power of a PoE interface
Peak power of a PoE interface
Maximum power of a PoE interface
Current of a PoE interface
Voltage of a PoE interface
Description of the PD connected to the PoE interface,
which is used to identify the type and location of the PD.
Chapter 1 PoE Configuration Commands
Description
1-5