H3C S7500E Series Command Manual page 1467

Command Manual – PoE
H3C S7500E Series Ethernet Switches
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Description
Use the display poe interface command to display the power information of the
specified interface.
If no interface is specified, the power information of all PoE interfaces is displayed.
Examples
# Display the power state of Ethernet 2/0/2.
<Sysname> display poe interface Ethernet 2/0/2
Port Power Enabled
Port Power Priority
Port Operating Status
Port IEEE Class
Port Detection Status
Port Power Mode
Port Current Power
Port Average Power
Port Peak Power
Port Max Power
Port Current
Port Voltage
Port PD Description
Table 1-2 Description on the fields of the display poe interface ethernet command
Port Power Enabled
Port Power Priority
Field
PoE state: enabled/disabled
enable: PoE is enabled.
disable: PoE is disabled.
Power priority of the PoE interface:
critical (highest)
high
low
Chapter 1 PoE Configuration Commands
: enable
: critical
: on
: 0
: delivering-power
: signal
: 5400 mW
: 5490 mW
: 6500 mW
: 15400 mW
: 108 mA
: 50.8 V
: IP Phone For Room 101
Description
1-4