Display Ospfv3 Request-List - H3C S7500E Series Command Manual

Command Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Total
Table 3-9 Description on the fields of the display ospfv3 peer statistic command
Field
Area ID
Down
Init
2-Way
ExStar
Exchange
Loading
Full
Total

3.1.12 display ospfv3 request-list

Syntax
display ospfv3 [ process-id ] request-list [ { external | inter-prefix | inter-router |
intra-prefix | link | network | router } [ link-state-id ] [ originate-router ip-address ] |
statistics ]
View
Any view
Parameters
process-id: OSPFv3 process ID, in the range 1 to 65535.
external: Displays the AS-external LSA information of the OSPFv3 link state request
list.
inter-prefix: Displays the Inter-area-prefix LSA information of the OSPFv3 link state
request list.
inter-router: Displays the Inter-area-router LSA information of the OSPFv3 link state
request list.
0 0 0
Area ID
In this state, neighbor initial state, the router has not received any
information from a neighboring router for a period of time.
In this state, the device received a Hello packet from the neighbor
but the packet contains no Router ID of the neighbor. Mutual
communication is not setup.
Indicates mutual communication between the router and its
neighbor is available. DR/BDR election is finished under this state
(or higher).
In this state, the router decides on the initial DD sequence
number and master/slave relationship of the two parties.
In this state, the router exchanges DD packets with the neighbor.
In this state, the router sends LSRs to request the neighbor for
needed LSAs.
Indicates LSDB synchronization has been accomplished between
neighbors.
Total number of neighbors under the same state
3-15
Chapter 3 IPv6 OSPFv3 Configuration Commands
0 0
Description
0 1