Secondary Authorization - H3C S7500E Series Command Manual

Command Manual – AAA RADIUS HWTACACS
H3C S7500E Series Ethernet Switches

1.3.16 secondary authorization

Syntax
secondary authorization ip-address [ por-number t ]
undo secondary authorization
View
HWTACACS scheme view
Parameters
ip-address: IP address of the server, a valid unicast address in dotted decimal notation.
The default is 0.0.0.0.
port-number: Port number of the server. It ranges from 1 to 65535 and defaults to 49.
Description
Use the secondary authorization command to specify the secondary HWTACACS
authorization server.
Use the undo secondary authorization command to remove the configuration.
Note that:
The IP addresses of the primary and secondary authorization servers cannot be
the same. Otherwise, the configuration fails.
The HWTACACS service port configured on the device and that of the
HWTACACS server must be consistent.
If you configure the command for more than one time, the last configuration takes
effect.
You can remove an authorization server only when no active TCP connection for
sending authorization packets is using it.
Related commands: display hwtacacs.
Examples
# Configure the secondary authorization server.
<Sysname> system-view
[Sysname] hwtacacs scheme hwt1
[Sysname-hwtacacs-hwt1] secondary authorization 10.163.155.13 49
1.3.17 stop-accounting-buffer enable
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
Chapter 1 AAA/RADIUS/HWTACACS
1-73
Configuration Commands