H3C S7500E Series Command Manual page 668

Command Manual – IPv6 Configuration
H3C S7500E Series Ethernet Switches
Examples
# Display the IPv6 information of VLAN-interface 2.
<Sysname> display ipv6 interface vlan-interface 2
Vlan-interface2 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::1234:56FF:FE65:4322
Global unicast address(es):
2001::1, subnet is 2001::/64
Joined group address(es):
FF02::1:FF00:1
FF02::1:FF65:4322
FF02::2
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
Table 1-5 Description on fields of the display ipv6 interface command
Vlan-interface2 current state
Line protocol current state
IPv6 is enabled
link-local address
Global unicast address(es)
Joined group address(es)
MTU
ND DAD is enabled, number of DAD
attempts
ND reachable time
ND retransmit interval
Field
1-6
Chapter 1 IPv6 Basics Configuration Commands
Description
Physical state of the interface
Link layer protocol state of the interface
IPv6 packet forwarding state of the
interface (IPv6 packet forwarding is
enabled in the example)
Link-local address configured for the
interface
Aggregatable global unicast address(es)
configured for the interface
Address(es) of multicast group(s) that the
interface joins
Maximum transmission unit of the interface
Number of DAD attempts, with DAD
enabled
Neighbor reachable time
Interval for retransmitting a neighbor
solicitation (NS) message